Power Management Setup - ECS RS482M-M Manual

Onboard Parallel Port (378/IRQ7)
This option is used to assign the I/O address and interrupt request (IRQ) for the onboard
parallel port.
Parallel Port Mode (SPP)
Enables you to set the data transfer protocol for your parallel port. There are four options:
SPP (Standard Parallel Port), EPP (Enhanced Parallel Port), ECP (Extended Capabilities
Port) and ECP+EPP.
• ECP Mode Use DMA (3):When the onboard parallel port is set to ECP mode,
the parallel port can use DMA 3 or DMA 1.
Press <Esc> to return to the Integrated Peripherals page.
Init Display First (PCI Slot)
Use this item to specify whether your graphics adapter is installed in one of the PCI
slots or is integrated on the motherboard. If a PCI graphics card is installed, the
onboard VGA will be disabled.
• Surroundview (Disabled):This item allows you to enable or disable
Surroundview function. Surroundview
nience of multiadapter, multimonitor support for computers that use an AGP or
PCI-E based graphics card in conjunction with ATI integrated graphics pro-
cessors.

Power Management Setup

This option lets you control system power management. The system has various power-
saving modes including powering down the hard disk, turning off the video, suspending
to RAM, and software power down that allows the system to be automatically resumed
by certain events.
Phoenix-Award WorkstationBIOS CMOS Setup Utility
ACPI Suspend Type
HDD Power Down
Video Off Option
Video Off Method
MODEM Use IRQ
Soft-Off by PWRBTN
Power After Power Fail
Resume Event Control
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values
ACPI Suspend Type (S3(STR)
Use this item to define how your system suspends. In the default, S3 (STR), the suspend
mode is a suspend to RAM, i.e., the system shuts down with the exception of a refresh
current to the system memory.
provides the power and conve-
TM
Power Management Setup
Item Help
[S3(STR)]
[Disabled]
Menu Level
[Susp, Stby --> Off]
[V/H SYNC+Blank]
[3]
[Instant-Off]
[Off]
[Press Enter]
F6:Fail-Safe Defaults F7:Optimized Defaults
Using BIOS
43