ECS RS482M-M Manual page 44

38
CKE base power down mode (Enabled)
When in power down mode, if all pages of the DRAMs associated with a CKE pin are
closed, then these parts are placed in power down mode. Only pre-charge power down
mode is supported, not active power down mode.
CKE based powerdown (Per Channel)
The DRAM channel is placed in power down when all chip selects associated with the
channel are adle.
Memclock tri-stating (Disabled)
This item enables or disables memclock tri-stating function.
Memory Hole Remapping (Disabled)
This item allows users to enable or disable memory hole remapping.
Botton of UMA DRAM [31:24] (FC)
This item is used to set the bottom of UMA DRAM [31:24]. We strongly recommend
that you leave this item at its default setting.
1T/2T (default)
This item allows users to manually specify thr DRAM memory time mode.
Press <Esc> to return to the Advanced Chipset Features page.
LDT & PCI Bus Control (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
LDT Configuration
Upstream LDT Bus Width
Downstream LDT Bus Width
LDT Bus Frequency
PCIE Reset Delay
LDT Configuration (Enabled)
This item enables or disables the LDT configuration.
Upstream LDT Bus Width (16 bit)
This item allows users to manually adjust the upstream LDT bus width to be 8 bit or 16 bit.
Downstream LDT Bus Width (16 bit)
This item allows users to manually adjust the downstream LDT bus width to be 8 bit or 16
bit.
Phoenix-Award WorkstationBIOS CMOS Setup Utility
LDI & PCI Bus Control
[Enabled]
[16 bit]
[16 bit]
[Auto]
[Disabled]
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values F6:Fail-Safe Defaults
Using BIOS
Item Help
Menu Level
F7:Optimized Defaults