ECS RS482M-M Manual page 50

44
HDD Power Down (Disabled)
The IDE hard drive will spin down if it is not accessed within a specified length of time.
Options are from 1 Min to 15 Min and Disable.
Video Off Option (Suspend —> Off)
This option defines if the video is powered down when the system is put into suspend mode.
Video Off Method (V/H SYNC+Blank)
This item defines how the video is powered down to save power. This item is set to DPMS
(Display Power Management Software) by default.
MODEM Use IRQ (3)
If you want an incoming call on a modem to automatically resume the system from a power-
saving mode, use this item to specify the interrupt request line (IRQ) that is used by the
modem. You might have to connect the fax/modem to the motherboard Wake On Modem
connector for this feature to work.
Soft-Off by PWRBTN (Instant Off)
Under ACPI (Advanced Configuration and Power management Interface) you can create a
software power down. In a software power down, the system can be resumed by Wake Up
Alarms. This item lets you install a software power down that is controlled by the power
button on your system. If the item is set to Instant-Off, then the power button causes a
software power down. If the item is set to Delay 4 Sec. then you have to hold the power
button down for four seconds to cause a software power down.
Power After Power Fail (Off)
This item enables your computer to automatically restart or return to its operating status.
Resume Event Control (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Resume By Ring
Resume By PCI PME
Resume By PCI-E PME
Resume By USB (S3)
Resume By WOL
Resume By PS2 MS(S3)
Resume By PS2 KB(S3)
x Resume By Hot Key
RTC Alarm Resume
x
Date (of Month)
x
Resume Time (hh:mm:ss)
: Move
F5:Previous Values
Resume by Ring (Disabled)
This item specifies whether the system will be awakened from power saving modes when
activity or input signal of WOL/WOM/Ring device is detected.
Resume by PCI PME (Enabled)
This item specifies whether the system will be awakened from power saving modes when
activity or input signal of the specified hardware peripheral or component is detected.
Phoenix-AwardBIOS CMOS Setup Utility
Resume Event Control
[Disabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Disabled]
Ctrl-F1
[Disabled]
0
0: 0: 0
Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F6:Fail-Safe Defaults
Using BIOS
Item Help
Menu Level
F7:Optimized Defaults