ECS RS482M-M Manual page 42

36
ATA 66/100 IDE Cable Msg. (Enabled)
This item enables or disables the display of the ATA 66/100 Cable MSG.
Typematic Rate Setting (Disabled)
If this item is enabled, you can use the following two items to set the typematic rate and the
typematic delay settings for your keyboard.
• Typematic Rate (Chars/Sec): Use this item to define how many characters
per second are generated by a held-down key.
• Typematic Delay (Msec): Use this item to define how many milliseconds
must elapse before a held-down key begins generating repeat characters.
Security Option (Setup)
If you have installed password protection, this item defines if the password is required at
system start up, or if it is only required when a user tries to enter the Setup Utility.
• APIC Mode (Enabled):This item allows you to enable or disable the APIC
(Advanced Programmable Interrupt Controller)mode.APIC provides symmetric
multi-processing (SMP) for systems, allowing support for up to 60 processors.
OS Select For DRAM > 64 MB (Non-OS2)
This item is only required if you have installed more than 64 MB of memory and you are
running the OS/2 operating system. Otherwise, leave this item at the default.
HDD S.M.A.R.T Capability (Disabled)
The S.M.A.R.T. (Self-Monitoring, Analysis, and Reporting Technology) system is a
diagnostics technology that monitors and predicts device performance S.M.A.R.T.
software resides on both the disk drive and the host computer.
The disk drive software monitors the internal performance of the motors, media, heads
and electronics of the drive. The host software monitors the overall reliability status of
the drive. If a device failure is predicted, the host software, through the Client WORKS
S.M.A.R.T applet, warns the user of the impending condition and advises appropriate
action to protect the data.
Full Screen LOGO Show (Enabled)
Enables or disables the display of the Full Screen Logo during boot-up.
Small Logo (EPA) Show (Disabled)
Enables or disables the display of the EPA logo during boot.
Press <Esc> to return to the main menu setting page.
Using BIOS