Machine Programming - Newco FKP-4 Manual

THESE MACHINES ARE EQUIPPED WITH A FLOWMETER-
pod brewer a few times. If the volume dispensed is comparable to the amount expected from
your Button Settings (which are set in the programming menu as described BELOW) and
consistent and the pulsing is acting as expected you are done. However if your dispensed
volume is larger or smaller than expected the easiest way to adjust it is to adjust the "OZ PER
TICK" using the FLOWMETER ADJUST feature in the programming menu.
NOTE: THE MACHINE HAS BEEN CALIBRATED AT THE FACTORY AND HAS BEEN ADJUSTED TO
BREW INTO AN 8 OUNCE CUP WITH APPROX 7 OUNCES OF COFFEE FOR BREW STRENGTHS OF
MILD, REGULAR AND BOLD. NO FURTHER ADJUSTMENTS ARE NECESSARY IF THE FACTORY
DEFAULTS ARE USED.
The Fresh Cup pod brewer has a menu that consist of scrolling menu entries that can be
scanned through backward and forward using button A and button B (see Fig 1). To enter a
programming record, press and hold the Hot Water Key (G) when powering up machine (see Fig
1) Then use button A and button B (see Fig 1) to change the entry. Pressing the Hot Water (G)
key (see Fig 1) will exit the entry, saving the entire Parameter structure to memory upon exiting
the programming menu using the
on one sub menu, which is accessed through the
in the Main menu are as follows:

MACHINE PROGRAMMING

A
B C
Fig 1: Fresh Cup Keys
END
entry. There are eight entries on the Main menu and four
Set Temperature
Set Energy Save Mode
SetEnergySaveTime
Set Buzzer Volume
Set Pod Count
Flowmeter Adjustment
Recipe Settings
Select Water Filter
Exit Menu
D E
BUTTON SET UP
8
Please run your Fresh Cup
G
F
entry. The current entries