Newco FKP-4 Manual page 9

MACHINE PROGRAMMING CONT'D
Set Temperature
170 to 205 degrees Fahrenheit with the default at 200 degrees F. As with most of the entries,
button A and button B (see Fig 1) will change the set point, incrementing or decrementing by
one. Pressing the Hot Water key (G) (see Fig 1) will exit.
Set Energy Save Mode
Use button A and button B (see Fig 1) to change the entry then press the Hot Water (G) key to
exit.
Off Mode (default) –No Energy Save
Energy Save– Partial Power Save Mode. After the user selectable time out the tank
temperature set point is set to 180 until a key is pressed.
Full Energy Save – Full Power Save Mode. After the user selectable time out the tank heater
is disabled until a key is pressed.
Set Energy Save Time
has been turned off. This entry sets the time the machine will operate normally until the power
save function is activated. The user can choose 1 through 4 hours in 1-hour increments with the
default set to 4 hours. As with most of the entries, button A and button B (see Fig 1) will change
the time, incrementing or decrementing by one. Pressing the Hot Water key (G), (see Fig 1) will
exit.
Set Buzzer Volume
Set Pod Count
before signaling that the bin is full. The range is 10 to 100 pods, with the default at 50. Setting
the pod count under 10 turns off the count so the bin full alarm will never go off. As with most of
the entries button A and button B (see Fig 1) will change the Pod Count Threshold, incrementing
or decrementing by one. Pressing the Hot Water key (G), (see Fig 1) will exit.
: In this entry the user may set the tank temperature in the range of
: This entry allows the user to select the Power Save mode.
: This entry will not be displayed if the Power Save function
: The range is from 0 to 100. The default is 20.
: In this entry the user may set the number of pods the brewer will hold
9