Newco FKP-4 Manual page 11

MACHINE PROGRAMMING CONT'D
Select Water Filter
on the inlet for the water. Choices include OFF, 500 GAL UP TO 3000 GAL. These set the counter
for the filter warning. Whenever water is dispensed the counter is incremented to account for
the water dispensed. When the counter is above 90% of the capacity of the chosen filter a
warning message, "CHECK FILTRATION", is displayed in place of the "READY" message. To
reset the counter the user must enter the programming menu and enter the RESET FILTER entry
described below. The following entries only show when a filter is selected. If the filter selection
is OFF then following entries are not available. Pressing the Hot Water key (G) (see Fig 1) to
leave the entry and return to the Main Programming menu.
GAL. REMAINING
replaced. Pressing the Hot Water key (G) (see Fig 1) to leave the entry and return to the Main
Programming menu.
RESET FILTER
: When in this entry the message "PRESS OPEN TO RESET FILTER'. Press the
Open Door key will reset the Filter Use counter to the value chosen in the SELECT WATER
FILTER entry above. Pressing the Hot Water key (G) (see Fig 1) to leave the entry and return to
the Main Programming menu.
EXIT MENU:
: This entry allows the user to select the filter size for the filter used
: This entry scrolls the number of Gallons left before the filter should be
– Exit to Ready to Brew Mode and save parameters.
11