Programming -Machine Calibration - Newco Bistro 10 T3 Operating Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

3. Select

"Calibration"

"LH Mix Bowl Cal", Insert a measuring container capable of holding 32 or more ounces

of water under delivery area of machine, then press the top left button to start calibration

countdown period of 30 seconds. (Note: if machine is not up to temperature, machine will

wait until temperature is reached before running calibration cycle, display will read

"Preparing to Brew") At the end of the calibration cycle, display will change to "Adjust LH

Mix bowl Cal"

Enter the value measured (Step 5, above right) and press the Upper Right button when

done- screen will change to "LH Mix Bowl Cal" again. This is in case there was a spill or

problem during the cycle and the measurement needs to be repeated- - to repeat press

Dump

the top right button to restart cycle.

Valves

"RH Mix Bowl Cal", Insert a measuring container capable of holding 32 or more ounces

of water under delivery area of machine, then press the top left button to start calibration

countdown period of 30 seconds. (Note: if machine is not up to temperature, machine will

wait until temperature is reached before running calibration cycle, display will read

"Preparing to Brew") At the end of the calibration cycle, display will change to "Adjust

RH Mix bowl Cal"

Enter the value measured (Step 5, above right) and press the Upper Right button when

done- screen will change to "RH Mix Bowl Cal" again. This is in case there was a spill or

problem during the cycle and the measurement needs to be repeated- - to repeat press

the top right button to restart cycle.