Procedure For Charging From A Domestic Power Socket (Ac) - Jeep RENEGADE 2023 Quick Manual

ATTENTION
29) The charging current level ("Level
1" / "Level 2" / "Level 3", etc.) can only
be changed via the Uconnect™ system
display (see the "Uconnect™" chapter
in the "Multimedia" section of the online
Owner Handbook for more information).
The default charge level set is "Level
3". For countries in which the 13A
"Mode 2" charging cable can be used,
if the domestic power socket IS NOT
CERTIFIED, it is recommended to set
"Level 4" charge to the maximum, which
corresponds to approx. 10A. For the list of
country-specific cable types refer to what
is indicated in the "Mode 2 cable variant
table" in the online Owner Handbook.
30) In order to reduce the risk of electric
shock or damage to the device, special
care should be taken when cleaning:
ALWAYS unplug the device from the
domestic power supply socket and car
ports.
24
WARNING
2) Avoid leaving the battery for several
days with the charge indicator at or near
zero. The high-voltage battery may be
damaged.
PROCEDURE FOR CHARGING
FROM A DOMESTIC POWER
SOCKET (AC)
31) 32) 33) 34) 35) 36) 37)
3) 4) 5) 6) 7) 8) 9) 10)
WARNING Always connect the cable to the
charging port of the domestic mains fi rst and
only then to the car.
The high-voltage battery of the car is
charged by connecting the "Mode 2"
charging cable, supplied with the car, to an
AC charging socket.
Refer to the "Power sources that can be
used – Mode 2 cable" chapter in the online
Owner Handbook for the specifications of
the "Mode 2" cable.
To charge, proceed as follows:
 park the car safely (automatic
transmission gear lever in position "P"
– Park)
 engage the electric parking brake
 switch off the engine;
 take the charging kit located in the boot
 remove any dust that may have built up
on the charging connector and on the
charging port
 unroll the charging cable and connect it
to an AC charging port, fig. 31
31
NOTE From the moment the plug is
connected to the domestic mains charging
port, the 3 LEDs on the control unit of
the cable will fl ash for approx. 6 seconds
(control unit switching on phase.
 open the charging flap (A) fig. 32
located on the left side by pressing on
the area indicated by the arrow
J0A6000E