Table of Contents
Advertisement
5Ux24D Tower-to-Rack Kit Introduction
The IBM
Netfinity
5Ux24D Tower-to-Rack Kit converts a 5U server that is 61.0 cm (24 in.) deep from a
tower model to a rack model. You can then install the server into a rack cabinet that is at least 61.0 cm
(24 in.) deep.
The following parts come with the 5Ux24D Tower-to-Rack Kit:
Two release-latch-bracket assemblies (one left and one right)
Two server covers
One rack-model trim bezel
Two rack-support wheels
Two slide rails
One cable-management arm (comes partially assembled):
– Two rigid cable-management arms
– One flexible cable-management arm
– One hinge bracket
– Four hinge pins
One LED panel cable (required for some servers)
Cable straps
Miscellaneous hardware kit (includes screws, cage nuts, and clip nuts to install the server in a rack
cabinet)
IBM Safety Information booklet
One rack installation template
One or more system-specific service labels
One IBM Netfinity 5600 Hot-Plug SCSI Setup Utility diskette
This documentation
Note: The illustrations in this documentation might be slightly different from your hardware.
Tool requirements
You will need the following tools to install the 5Ux24D Tower-to-Rack Kit:
A small flat-blade screwdriver
A medium phillips screwdriver
An 8-mm open-end or box wrench
A 10-mm nut driver or a 10-mm open-end or box wrench
Copyright IBM Corp. 2000
1
Advertisement
Table of Contents
