Siemens Geared motors-Planetary gear Instructions Manual page 11

1 General safety instructions
These operating instructions contain all the necessary information concerning the
transport, installation, initial start up, maintenance etc. of geared motors.
This operating manual applies in conjunction with the SIEMENS project planning guide
and the operating manual "Three-Phase Servomotors".
The fulfillment of any rights under the warranty is conditional upon exact compliance with
the specifications and instructions in these operating instructions.
To prevent hazards of any kind arising during transport, storage, mounting, start
up, maintenance etc., the instructions relating to safety and hazards in these op-
erating instructions and the operating instructions for three-phase servomotors
(1FK7/1FT6) must be complied with, without fail. Failure to observe the instruc-
tions can lead to serious personal injuries or property damage.
Ensure that your end product conforms to all currently valid legal requirements.
Follow the compulsory national, local and installation-specific regulations.
These motors must not be brought into use until it has been established that the
end product conforms to the currently valid directives.
Mechanical hazards, arising for example from a freely revolving transmission shaft,
must be prevented by suitable protective devices. All the keys in the shafts must be
secured.
Prevent electrical hazards from arising by precisely following the instructions in the
"Initial start up" section.
The motors' rotors contain permanent magnets with high magnetic flux densities which
exert strong attractive forces on ferromagnetic bodies.
People fitted with a heart pacemaker are at risk in the vicinity of a disassembled
rotor. Data stored on electronic data media may be destroyed.
It is forbidden to use these servomotors in areas at risk of explosion, unless this is
expressly authorized.
The drive must be specially equipped by the manufacturer for operation outside the
permissible temperature range.
Do not touch the hot gearbox/motor casing with your bare hands. A high operating
temperature may cause burns or nervous reactions. The surface temperature of the
motors can reach > 100°C, that of the gear 90°C.
Do not touch hot surfaces!
Temperature-sensitive components (electric lines, electronic components) must not
touch hot surfaces. Overheating in the motors may destroy the windings and bearings,
and demagnetize the permanent magnets.
Only operate the motors with effective temperature control.
Intended Usage
Usage for the intended purpose includes observing all the specifications in the operating
manual and the project planning guide "Three-phase servomotors".
The gears/geared motors have been designed for the permissible outputs and loads
stated in the catalog. The geared motors may only be used for the purpose for which they
have been designed, taking all operating factors into account. Any overload of the drives
is deemed as not being use for the intended purpose. The manufacturer shall not be
liable for any damage ensuing from any unauthorized modifications to any part of the
drive.
Siemens AG
ENGLISH
610.40 072.01
11