Editing - Ricoh 3800C Operating Instructions Manual

Registering
- Programming the Group as a - - -
Transfer Station of a Multi-Step
Transfer
A group can be programmed as a
Transfer Station. You should pro-
gram the receiving stations when you
program the Group as a Transfer Sta-
tion.
For more information, contact your
3
service representative.
Limitation
❒ If you want to program a group
which has been programmed as a
Tra ns fe r S ta ti on as a n o rm al
group, delete the group and pro-
gram again.
❒ Only one destination can be pro-
grammed as a Transfer Station in a
group.
Note
❒ Before you program the group as a
Transfer Station, you must pro-
gram the Polling ID and your own
fax number. ⇒ Chapter 8, "Pro-
gramming a Polling ID", "Transfer
Report" in the Advanced Features
manual
Follow steps A to F in "Program-
A
ming".
B Press [Adv. Features].
C Press [Transfer Req.].
D
Press [Receiving Station].
E Specify the receiving station.
Note
❒ When you specify the receiving
station with Quick Dial, press
[Quick Dial] and enter the Group
Dial number using the number
keys.
70
❒ When you specify the receiving
station with Group Dial, press
[Group Dial] and enter the Group
Dial number using the number
keys.
F After specifying all of the receiving
stations, press [OK].
G Press [OK].
H Press [Exit].
Reference
⇒ Chapter 4, "Transfer Request",
Chapter 5, "Transfer Station" in
the Advanced Features manual

Editing

Use this procedure to change the
Groups already programmed.
Limitation
❒ When a programmed group is be-
ing used for a standby Memory
Transmission, the message "
ified destination is used by
transmission standby file.
It cannot be changed or de-
leted. Specify it again af-
t e r t r a n s m i s s i o n
" is shown. You can-
completed.
not change the destinations for this
key at this time.
A A A A
Press [Dest. Management].
Spec-
i s