Siemens SIWAREX MS Device Manual page 2

Warning and Safety Terms
This manual contains notices that are for your personal safety and to prevent damage to
devices or surroundings. These notices are indicated by a warning triangle and are presented
as follows depending on the degree of danger:
!
Danger
means, that death, severe injury or considerable material damage may result, if
the respective safety measures are not taken.
!
Warning
Means that death, severe injury or serious material damage can result if the corresponding safety
precautions are not followed carefully.
!
Caution
Means that material damage or minor injuries can result if the corresponding safety precautions are
not followed carefully.
Caution
Means that material damage can result if the corresponding safety precautions
are not followed carefully.
Attention
Refers to important information on the product, handling of a product or a
corresponding segment of the documentation to which special attention should be
given.
Qualified Personnel
Commissioning and operation of a device may only be performed by qualified personnel. Qualified personnel as
indicated in the safety information in this manual are people that have the authorization to install, ground and label
devices, systems and power circuits.
Intended Utilization
Warning
!
The device may only be utilized for the applications described in the catalog and the technical
description and only in conjunction with external devices and components that are approved or
recommended by Siemens.
Fault-free and safe operation of the product depend on proper transport, proper storage, assembly,
installation, operation and maintenance.
Brand names / Trademarks
SIWAREX®, SIMATIC®, SIMATIC HMI® and SIMATIC NET® are trade marks of the Siemens
AG. The other designations in this info may be trade marks the use of which by third persons for
their own purposes might infringe proprietor rights.
©
Copyright Siemens AG 2005 All rights reserved
Circulation or duplication of this document, utilization and
disclosure of its contents are not permitted unless explicitly
approved. Offenders will be liable for damages. All rights
reserved, including rights created by granting of patents or
registration of a utility model or design.
Siemens AG
Automation & Drives Dept.
SIWAREX Weighing Systems
A&D PI 14
Östliche Rheinbrückenstr. 50
D-76187 Karlsruhe
iv
Disclaimer
We have tested the contents of this document for compatibility
with the hardware and software described. This does not
exclude the possibility of discrepancies, in which case we do
not guarantee the complete compatibility of this document. The
information in this document is assessed regularly and any
necessary corrections are included in the next revision.
We are grateful for any suggestions for improvement.
© Siemens AG 2005
Subject to change without notice.
SIWAREX MS