Employee Table Setting (Submode 50) - TEC FS-2600-1 SERIES Owner's Manual

5. PROGRAMMING OPERATIONS

Employee Table Setting (Submode 50)

This programming is used to assign a cashier code and a job code to each employee.
CONDITION After Employee Clock-in/Clock-out
Daily and GT Reset
OPERATION Mode Lock: SET
50 [X] |Employee Code| [NS]
Submode No.
Address No.
2 Cashier Code
Enter a manager-assign code (1 to 99). A cashier for which 0 has been entered for a
cashier code cannot sign ON on the register.
NOTE:
3 Job Code
Enter a max. 20-digit value combining the job codes 1 to 10. (When you enter a 1-digit
numeric 1 to 9, add 0 before the numeric.) As a result, a maximum of 10 job codes can be
assigned to each employee.
NOTE:
NOTE: A maximum of 200 employees can be managed.
ex.) To set the following to an employee No. 1.
Employee No. 1:
Guest Card Reading through the MCR
1 to 9999
*
* Repeatable from here if an employee code is sequential.
Employee Table Programming Contents
Description of Programming Contents
Do not set the same cashier code for multiple employees.
Each job definition should be programmed in the Job Code/ Working Hours Setting
(Submode 51).
Address 1 (Name):
Address 2 (Cashier Code):
Address 3 (Job Code):
When you enter 50 and depress the [X] key,
the screen shown below will appear.
* SET * 02-06-1999 12:34
PROGRAMMING
Please input Employee code.
Pg up
Address 1: Employee Name
1 [ST]
Address 2: Cashier Code
2 [ST]
Address 3: Job Code
3 [ST]
Repeat for another employee.
JONES
1
010203 (Job Code 1,2,3)
5-49
5.4 How to Access a Program Item
EMPLOYEE
0.00
Pg dw Enter
Character Entries [ST]
Max. 12 characters
|Cashier Code| [#]
0 to 99
|Job Code| [#]
Max. 20 digits
EO1-11138
[AT/TL]