Dll (Down-Line-Loading) Operations - TEC EO1-11099 Owner's Manual

5. DLL (Down-Line-Loading) OPERATIONS

In an in-line system (Master-Satellite system), most programming data are set on the Master Termi-
nal and down-line-loaded (DLL) to Satellite Terminals. The DLL operations introduced in this chapter
are pure DLLs, i.e. merely loading the data programmed in the Master Terminal to Satellite Termi-
nals. DLLs automatically performed with programmed data changes are introduced in the next
chapter (Chapter 6). If any other DLLs not introduced in this and next chapters are required, ask
your TOSHIBA TEC representative. Please also note that TERMINAL DESIGNATION (see Chapter
2) can be operated prior to a specific DLL operation, to designate Satellite Terminals that receive the
DLL.
DLL JOB LIST
Submode No.
501 Store Name/Message and Commercial Message Programming
502 Cashier Code and Name Programming
504 PLU Table Programming
505 Time/Date Setting
508 Amount Limit Setting for Function Keys
520 Salesperson Code and Name Programming
526 Tare Table and General Unit Weight Setting
PLU Preset-code Key Setting
527
Display Message Programming
531
Negative Amount Key Limit Amount Setting
535
Set Menu Table Programming
542
Terminal Connection Table Setting
569
%+ and %- Preset Rate Setting
Preset Rate Setting for Selective Itemizers
500 Foreign Currency Exchange Rate Setting
Tax Table Programming
GST Rate Setting
NOTE: DLL is possible only when the non-floating cashier feature is used.
DLL Job
- 20 -
EO1-11113
Remarks
NOTE below