Installing The Journal Roll - TEC EO1-11099 Owner's Manual

Installing the Journal Roll

1
Follow Steps 1 to 5 for "Installing the Receipt Roll" on the preceding pages, except that
the paper roll should be placed inner side holder of the two holders.
2
There are the following two ways of a journal paper feed procedure.
A: Manual installation
B: Installation using the [JF] key
A: Manual installation
B: Installation using the [JF] key
Lift the green lever on the journal side.
Insert paper from the rear of the printer until
the leading edge of paper comes out by 30
cm.
Insert the leading edge of paper into the slit
of the take-up reel to take up paper two or
three times.
Place the take-up reel on the take-up holder.
Lower the green lever.
Attach the receipt cover.
Insert paper from the rear of the printer until
it won't go no further.
Press the [JF] key to feed paper until the
leading edge of paper comes out by 30 cm.
Insert the leading edge of paper into the slit
of the take-up reel to take up paper two or
three times.
Place the take-up reel on the take-up holder.
Attach the receipt cover.
- 12 -
EO1-11113