YASKAWA L1000A Series Technical Manual page 210

5.10 o: Operator Related Settings
■ o2-03: User Parameter Default Value
No.
Setting 0: No change (awaiting command)
Setting 1: Set User Initialize values
Setting 2: Clear User Initialize Values
■ o2-04: Drive Model Selection
D rive p e rfo rm a n c e w ill s u ffe r a n d p ro te c tiv e fun ctions w ill n o t op e ra te p ro p e rly i f the co rre ct drive cap acity is n o t s e t to o2-04.
No.
■ o2-05: Speed Reference Setting Method Selection
No.
Setting 0: ENTER key required
Setting 1: ENTER key not required
■ o2-06: Operation Selection when Digital Operator is Disconnected
No.
Setting 0: Continue operation
Setting 1: Trigger a fault
Refer to A1-03: Initialize Parameters on page 135
Name
Defaults by Drive Model Selection (o2-04) on page 363.
Name
Name
Name
Setting Range Default
Setting Range Default
Setting Range Default
Setting Range Default