YASKAWA L1000A Series Technical Manual page 137

■ b1-08: Up/Down Command Selection while in Programming Mode
No.
Setting 0: Disabled
Setting 1: Enabled
Setting 2: Prohibit programming during run
■ b1-14: Phase Order Selection
No.
Setting 0: Standard phase order (U-V-W)
Setting 1: Switched phase order (U-W-V)
♦ b2: Magnetic Flux Compensation
■ b2-08: Magnetic Flux Compensation Value
No.
Parameter Name
Parameter Name
Name
5.2 b: Application
Setting Range Default
Setting Range Default
Setting Range Default
1