Power Cord Specifications - Cisco SE-CL-L3 Installation Manual

Server Specifications
Table 10: 1050 W AC Specifications
Description
AC Input Voltage
AC Input Frequency
Maximum AC Input current
Maximum input volt-amperes
Maximum inrush current
Maximum hold-up time
Maximum output power per PSU
Power supply output voltage
Power supply standby voltage
Efficiency rating
Form factor
Input connector

Power Cord Specifications

Each power supply in the server has a power cord. Standard power cords or jumper power cords are available
for connection to the server. The shorter jumper power cords, for use in racks, are available as an optional
alternative to the standard power cords.
Note
Only the approved power cords or jumper power cords listed below are supported.
Table 11: Supported Power Cords
Description
CAB-48DC-40A-8AWG
DC power cord, -48 VDC, 40 A, 8 AWG
Three-socket Mini-Fit connector to three-wire
Specification
Nominal range: 100–120 VAC, 200–240 VAC
(Range: 90–132 VAC, 180–264 VAC)
Nominal range: 50 to 60Hz
(Range: 47–63 Hz)
12.5 A at 100 VAC
6.0 A at 208 VAC
1250 VA at 100 VAC
15 A (sub-cycle duration)
12 ms at 1050 W
800 W at 100–120 VAC
1050 W at 200–240 VAC
12 VDC
12 VDC
Climate Savers Platinum Efficiency (80Plus Platinum certified)
RSP2
IEC320 C14
Length (Feet) Length (Meters)
11.7 3.5
Cisco Application Services Engine Hardware Installation Guide
Power Cord Specifications
87