Table of Contents
Advertisement
Maintaining the Server
Figure 18: Replacing a Drive in a Drive Tray
1
Ejector lever
2
Release button
Installing a PCIe Cable For Front-Loading NVMe SSDs
The front-loading NVMe SSDs interface with the server via the PCIe bus. Cable CBL-NVME-C220FF
connects the front-panel drive backplane to the PCIe riser 2 board on the PCIe riser assembly.
• If the server was ordered with 2.5- or 3.5-inch form-factor NVMe SSDs, this cable was preinstalled at
• If you are adding 2.5- or 3.5-inch form-factor NVMe SSDs for the first time, you must order and install
the factory. No action is required.
the cable as described in the following procedure.
Installing a PCIe Cable For Front-Loading NVMe SSDs
3
Drive tray screws (two on each side)
4
Drive removed from drive tray
Cisco Application Services Engine Hardware Installation Guide
37
Hide quick links:
Advertisement
Table of Contents
