Table of Contents
Advertisement
plication. The correct power tool will
do the job better and safer at the rate
for which it was designed.
Do not use the power tool if the
b.
switch does not turn it on and off.
Any power tool that cannot be con-
trolled with the switch is dangerous
and must be repaired.
c.
Disconnect the plug from the
power source before making any
adjustments, changing accesso-
ries, or storing power tools. Such
preventive safety measures reduce
the risk of starting the power tool ac-
cidentally.
d.
Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to oper-
ate the power tool. Power tools are
dangerous in the hands of untrained
users.
e.
Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If dam-
aged, have the power tool repaired
before use. Many accidents are
caused by poorly maintained power
tools.
f.
Keep cutting blades sharp and
clean. Properly maintained cutting
blades with sharp cutting edges are
less likely to bind and are easier to
control.
g.
Use the power tool and its acces-
sories in accordance with these
instructions, taking into account
the working conditions and the
work to be performed. Use of the
power tool for operations different
SKU 66435
For technical questions, please call 1-800-444-3353.
from those intended could result in a
hazardous situation.
5.
Service
a.
Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
Specific Safety Warnings
1.
Always wear ANSI-approved
safety impact goggles when
using the Bandsaw.
2.
WARNING! Keep hands and
fingers away from the cutting
area and Saw Blade.
3.
CAUTION! Cut only
es when the Bandsaw is in its verti-
cal position. NEVER attempt to cut
pipes or other round objects with the
Bandsaw in its vertical position.
4.
Make sure the Bandsaw is located on
a flat, level, sturdy floor surface ca-
pable of supporting the weight of the
Bandsaw and workpieces. Always
"chock" the Wheels to prevent the
Bandsaw from accidently moving.
5.
Before using the Bandsaw, check that
the Saw Blade is properly mounted
and is not cracked or bent.
6.
Make sure the Table of the Bandsaw
and surrounding area are clear with
the exception of the workpiece to be
cut.
7.
Never stand on the Bandsaw. Seri-
ous injury could result if the Bandsaw
is tipped or if the rotating Saw Blade
is accidently contacted.
FLAT workpiec-
Page 5
Advertisement
Table of Contents
