If Your Copier Does Not Operate As You Want - Ricoh FT4018 Operating Instructions Manual

IF YOUR COPIER DOES NOT OPERATE AS YOU WANT

IF YOUR COPIER DOES NOT OPERATE AS
Check the followings:
Copier's condition
Nothing happens when the main
switch is turned on.
d
is lit.
f
is blinking or lit.
Y
is lit.
Energy Saver is lit.
U code is displayed on the
copy counter.
"E" and number are alternately dis-
played on the copy counter .
44
Check the power cord. Is it properly plugged
into the outlet?
Plug it in firmly.
Load paper.
Add toner.
Remove misfed paper.
Your machine is in the Energy Saver condition.
Press any key except the Start key to
return to the ready condition.
U1 Close the right side cover .
The copier is set for user codes. Enter your user
U2
coed.(4digits)
U4 Reset the optional sorter correctly.
U6 Call your service representative.
Turn the main switch off, wait a few seconds,
and then turn it on. If the E code appears again,
call your service representative and tell which
code is on.
YOU WANT
Action
See page 47 ~ 49.
See page 50.
See page 51 ~ 53.