Secure Cables At The Transceiver Unit - Siemens SIMATIC HMI Series Operating Instructions Manual

3.5.6.2

Secure cables at the Transceiver Unit

The USB cable and the power supply cables connected to the Transceiver Unit must be
secured using the supplied fastening elements.
To install the fastening elements and secure the cables, proceed as follows:
1. Hang the fastening elements
from the scope of delivery at
an angle of approx. 60° to the
vertical from below into the
corresponding opening in the
enclosure of the
Transceiver Unit.
2. Swivel the fastener to the
vertical position.
3. Secure the power supply
cables and the USB cable
with cable ties on the
respective fastener.
Make sure that the cables are
not crushed by the cable tie.
IFP V2, IFP V2 PRO
Operating Instructions, 08/2019, A5E46641410-AA
Installing and connecting the device
3.5 Connecting the device
71