Transceiver Unit; Permissible Mounting Positions; Required Clearance - Siemens SIMATIC HMI Series Operating Instructions Manual

3.1.4

Transceiver Unit

3.1.4.1

Permissible mounting positions

The following mounting positions are permissible for the Transceiver Unit:
Mounting on the rear
The Transceiver Unit can be mounted on a DIN rail or on a wall using screws.
The interfaces of the Transceiver Unit should always point downwards.
3.1.4.2

Required clearance

The following clearance is required around the Transceiver Unit:
● At least 14 mm above the the Transceiver Unit for the mounting rail
● At least 80 mm below the Transceiver Unit for the fastening elements for strain relief
The following figure shows an example with a mounting rail attached to the rear of the
Transceiver Unit. The device depth of Transceiver Unit with mounting rail is 35.2 mm.
y1 14 mm
y2 80 mm
IFP V2, IFP V2 PRO
Operating Instructions, 08/2019, A5E46641410-AA
Installing and connecting the device
3.1 Preparing for installation
Mounting on one side
43