Siemens SIMATIC HMI Series Operating Instructions Manual page 61

Wiring diagram
The following figure shows the connection of the equipotential bonding using IFP1500 V2 as
an example and similarly applies to the all Flat Panels and the Transceiver Unit.
Note
Cable routing for PRO devices
As the PRO device is not installed in a control cabinet but on a pedestal or support arm, the
connecting cables must be routed through the support arm or the pedestal. The cable cross-
sections specified for the built-in devices also apply to the PRO devices.
Make sure to consult the corresponding connection diagrams in the Quick Install Guide
supplied with your PRO device.
①
②
③
④
⑤
⑥
IFP V2, IFP V2 PRO
Operating Instructions, 08/2019, A5E46641410-AA
Control cabinet
Equipotential bonding cable, 4 mm
Equipotential busbar for equipotential bonding cables, grounding connection and shield support in
extended mode
Data cable to the Transceiver Unit in extended mode
Cable clip
Ground bar, 16 mm
2
Installing and connecting the device
2
3.5 Connecting the device
61