Installing and connecting the device
3.1 Preparing for installation
3.1.4.3
Fastening the mounting rail
Requirements
To attach the mounting rail to the Transceiver Unit you need:
● The supplied mounting rail
● The supplied cross-tip cylinder head screw
● A torque screwdriver with cross-tip insert
Procedure
For attachment on DIN rail or on the wall, fasten the
mounting rail in one of the lateral or rear guides in the
enclosure of the Transceiver Unit according to the de-
sired mounting position.
The adjacent example shows the lateral mounting of
the mounting rail. The mounting rail is attached to the
rear of the Transceiver Unit in the same way.
Proceed as follows:
1. Push the mounting rail into the guide from below
until it stops.
2. Fasten the mounting rail using the supplied cross-tip
cylinder head screw, torque 0.8 Nm
44
Operating Instructions, 08/2019, A5E46641410-AA
IFP V2, IFP V2 PRO