Siemens SIMATIC NET SCALANCE W760 Series Configuration Manual page 85

● HT Channel Width [Mhz]
Shows the channel bandwidth.
– 20
– 40 up
– 40 down
● iFeatures
Shows which iFeatures are used.
– -
– iPCF
● Status
Shows the status of the WLAN interface.
– enabled
– disabled
Table 2 has the following columns:
● Radio
Shows the available WLAN interfaces in this column.
● Port
Shows the port of the virtual access point.
● MAC Address
Shows the MAC address of the virtual access point.
● SSID
Shows the SSID.
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
Configuration Manual, 11/2014, C79000-G8976-C350-03
Channel bandwidth 20 MHz
Channel bandwidth 40 MHz. The configured channel and the neighboring channel
above it are used.
Channel bandwidth 40 MHz. The configured channel and the neighboring channel
below it are used.
Note
Channel bandwidth 40 MHz and frequency band 2.4 GHz
If the access point detects another access point on the configured channel or on
neighboring channels, the access point changes the channel bandwidth from 40 MHz
to 20 MHz. If you set a "free" channel on the access point, the access point uses the
channel bandwidth 40 MHz.
iFeatures are not used.
The WLAN interface is enabled.
The WLAN interface is disabled.
Configuring with Web Based Management
5.4 "Information" menu
85