Siemens SIMATIC NET SCALANCE W760 Series Configuration Manual page 191

Description
Table 1 has the following columns:
● Radio
Shows the available WLAN interfaces in this column.
● MAC Mode
Specify how a MAC address is assigned to the client. The following are possible:
– Automatic
– Manual
– Own
– Layer 2 Tunnel
● MAC Address
If you have selected "Manual" for "MAC Mode", enter the MAC address of the client.
● Any SSID
– Enabled
– Disabled
● Roaming Threshold
Specify the threshold after which the client roams to the new access point.
– High
– Medium
– Low
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
Configuration Manual, 11/2014, C79000-G8976-C350-03
The client automatically adopts the source MAC address of the first frame that it
receives over the Ethernet interface.
If you select Manual, enter the MAC address in the "MAC Address" column.
The client uses the MAC address of the Ethernet interface for the WLAN interface.
The client uses the MAC address of the Ethernet interface for the WLAN interface.
The network is also informed of the MAC addresses connected to the Ethernet
interface of the client. Up to eight MAC addresses can be used.
In client mode, the access point attempts to connect to the network with the best
transmission quality and that has suitable security settings. The clients can only
connect to the access point on which the "Broadcast SSID" option is enabled.
The client attempts to connect to the access point from the SSID list that provides the
best transmission quality and on which the "Broadcast SSID" option is disabled.
Changes only at a significantly higher field strength to the AP with the stronger signal.
Changes at a moderately higher field strength to the AP with the stronger signal.
Changes at a slightly higher field strength to the AP with the stronger signal.
Configuring with Web Based Management
5.6 "Interfaces" menu
191