Siemens SIMATIC NET SCALANCE W760 Series Configuration Manual page 128

Industrial wireless lan to ieee 802.11n web based management
Table of Contents

Advertisement

Configuring with Web Based Management
5.5 "System" menu
Table 2 has the following columns:
● Event
The column contains the following values:
– Cold/Warm Start
– Link Change
– Authentication Failure
– Power Change
– Spanning Tree Change
– Fault State Change
– Overlap AP Detection (Only in access point mode)
– WDS (Only in access point mode)
– DFS (Only in access point mode)
– WLAN General (Only in access point mode)
– WLAN Authentication Log
– WLAN De/Authentication (Only in client mode)
– iPCF Poll Size (available only with client SCALANCE W722-1)
● E-Mail
The device sends an e-mail. This is only possible if the SMTP server is set up and the
"SMTP client" function is enabled.
● Trap
The device sends an SNMP trap. This is only possible if "SNMPv1 Traps" is enabled in
"System > Configuration".
● Log Table
The device writes an entry in the event log table.
128
The device was turned on or restarted by the user.
This event occurs only when the port status is monitored and has changed, see
"System > Fault Monitoring > Link Change".
This event occurs when attempting access with a bad password.
This event occurs only when power supply line 1 is monitored. It indicates that there
was a change to line 1, see "System > Fault Monitoring > Power Supply".
The STP or RSTP or MSTP topology has changed.
The fault status has changed. The fault status can relate to the activated port
monitoring, the response of the signaling contact or the power supply monitoring.
This event is triggered when there is an entry in the overlap AP list.
The connection status of a WDS link has changed.
This event occurs if a radar signal was received or the DFS scan was started or
stopped.
This event occurs if a the channel bandwidth has changed.
Forwarding of the entries from the WLAN Authentication Log to the system protocol
server.
With successful or failed WLAN authentication attempts.
This event occurs if the PNIO data size is too large for transfer.
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
Configuration Manual, 11/2014, C79000-G8976-C350-03

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents