HP Aruba 6400 Series Installation And Getting Started Manual page 86

2. Execute the no module <SLOT-NUM> command to deactivate the slot containing the line module you
are removing or replacing. For example, suppose slot 1/7 is active and contains a R0X38A line module. To
reset slot 1/7 to the default configuration, you would use this command:
Switch(config)# no module 1/7
For more information on module commands, see the Command-Line Interface Guide at https://
asp.arubanetworks.com/downloads.
3. Put on an ESD wrist strap and connect it to the ESD connection point on the front of the chassis. (See
Attaching an ESD wrist strap.)
4. Loosen the screws securing the line module to the chassis.
5. Open the extractor handles and pull the module out of its slot. Place the module in an antistatic bag for
protection from ESD damage.
6. If you do not plan to install another line module in the empty slot, then secure a line module slot cover
over the slot opening.
1
7. To install another line module in the empty slot:
a. Slide the line module part-way into the selected module slot.
b. Open the extractor handles.
c. Push the module into the slot until it stops.
86
2
3
2
1
Aruba 6400 Switch Series Installation and Getting Started
Guide