HP Aruba 6400 Series Installation And Getting Started Manual page 76

2. Attach three angle brackets to each cable manager bulkhead. Use the screws provided. (The Aruba 6405
Switch is shipped with two cable manager bulkheads. The Aruba 6410 Switch ships with four cable
manager bulkheads.)
3. Install the cable restraints on the cable manager bulkheads, as shown in step 1.
4. Position the cable manager bulkheads over the rack ears so that the holes in the attached angle brackets
line up with holes going through the rack ears to the screw holes in the rack posts. Install and tighten the
screws to secure the cable manager bulkheads on the rack posts.
76
2
1
1
1
1
2
2
2
Aruba 6400 Switch Series Installation and Getting Started
Guide