HP Aruba 6400 Series Installation And Getting Started Manual page 59

NOTE: The four-post slide rails support only square hole and round hole rack configurations.
They do not support threaded hole rack configurations.
The equipment rack shown in this publication is for illustration purposes only, and may not
match the equipment rack you are using.
Installing rack rails
Procedure
1. Select the desired rail position in the rack and install the adjustable rails by aligning the pins and
engaging the clips front and back. The rails require 2U of rack height. The rail pins fit in the bottom and
top rack holes in the lower 1U, and in the top rack hole in the upper 1U.
1 Rail pins
2 Rail clip
2. Secure both rails to the front and back posts with the included 10-32 screws.
Chapter 6 Mounting the switch
1
WARNING: Mount devices installed in a rack or cabinet as low as possible. Mount the
heaviest devices at the bottom of the rack and lighter devices higher up.
2
59