Section B: Installing Option 11C Mini Cables; Installing The Ntrh3502 Scsi Cable For Option 11C Mini - Nortel CallPilot 201i Hardware Installation

What is next?
Prepare the modem, CD-ROM drive, and tape drive for connection to the
201i server. For instructions, see
(page

Section B: Installing Option 11C Mini cables

In this section
"Installing the NTRH3502 SCSI cable for Option 11C Mini" (page 63)
"Installing cables on the back of the Option 11C Mini cabinet" (page 68)

Installing the NTRH3502 SCSI cable for Option 11C Mini

Introduction
Before you can connect a CD-ROM or tape drive to the 201i server, you
must install the NTRH3502 SCSI cable. The NTRH3502 SCSI cable routes
the SCSI connection away from the 201i server faceplate so that an external
SCSI device can remain permanently connected.
If the Option 11C Mini is equipped with a Fiber Routing Guide (consisting of
a spool and mounting bracket), you must remove it before you can install the
NTRH3502 SCSI cable, and then reinstall it when you are finished.
For detailed instructions on removing and installing the Fiber Routing Guide,
refer to the Option 11C and Option 11C Mini Expansion Guide
What the completed installation looks like
The following diagram shows how the intermediate SCSI cable, CD-ROM
drive, and tape drive are connected to the Option 11C Mini. In the diagram,
the CD-ROM drive is the first device. The tape drive is the last device.
Copyright © 2007, Nortel Networks
.
Installing the NTRH3502 SCSI cable for Option 11C Mini 63
89).
Nortel CallPilot
201i Server Hardware Installation
NN44200-301 01.01 Standard
5.0 15 February 2007
Chapter 7 "Preparing peripheral devices"
Nortel Networks Confidential