Replacing The Media Gateway Or Media Gateway Expansion Cover - Nortel CallPilot 201i Hardware Installation

82 Chapter 6 Installing the 201i server in the Communication Server 1000 system
3
4
5
6
What is next?
Continue with
system" (page

Replacing the Media Gateway or Media Gateway Expansion cover

Introduction
This section describes how to replace the front bezel and inside front cover
plate on the Media Gateway or Media Gateway Expansion.
To replace the inside front cover plate
The following diagram provides an overview of how to install the inside
front cover plate:
Copyright © 2007, Nortel Networks
.
Connect the low profile right-angle SCSI connector on the
NTRH3502 cable to the SCSI connector on the 201i server faceplate.
Fasten the SCSI cable drain wire to one of the screws that previously
held the inner SCSI bracket in place.
Notes:
•
Use the screw that is the most convenient.
• Press firmly on the drain wire Y-connector until it snaps into
place around the screw post.
Replace the inside front cover plate.
For instructions, see
82).
Ensure that the tabs on the bottom and right side of the inside front
cover plate are positioned inside the Media Gateway or Media Gateway
Expansion.
Replace the front bezel.
For instructions, see
"Connecting cables to the Communication Server 1000
85).
Nortel CallPilot
201i Server Hardware Installation
NN44200-301 01.01 Standard
5.0 15 February 2007
"To replace the inside front cover plate" (page
ATTENTION
"To replace the front bezel" (page
—End—
83).
Nortel Networks Confidential