Mitsubishi MELSEC-A Series Operating Manual page 38

3. SPECIFICATIONS
MELSEC-A
(Continued from the previous
page)
Functions
I
TD set(turn ONyreset(turn OFF) bit devices 6.7.1
To chanoe current values of word devices 6.7.2
Testing by list monitoring
~~ ~
To sewcancel offline switchs and separate des-
from ACPU operation processing. Or to cancel
6.7.3
To chame current values of word devices 6.7.4
Test by device monitoring
To display values in designated formats or
ASCII.
set(nnn ON)lreset(turn
OFF)
bit devices, and
to change current values of word devices
Same as the Test bv list monitorina
TEST (T) Display change
List monitoring
test
Device monitoring
test
Help
To display current values (including T/C set val-
ues) of the ONlOFF state of bit devices and
word devices
l -
Comment disDlav To displav comments of designated devices
1
6.2.4
All clear o
If
Darameters
To only clear parameters in an ACPU
I
6.8.1
To set memory capacities. timer counters, and
latch ranges, etc of all kinds of parameters 6.8.2
Or
to
chanoe set values
PARAMETER
P) Setting of parameters
To set entry codes 5.1.3
Or to change entry codes 6.6.2
To change set values of designated devices
fT/C)
6.9.1 Change of TIC set values
To display the descriptions of errors that occur
in an ACPU and the step numbers where errors 6.9.2
occur
Error step read
PC check
Program check
Link monitoring
Monitoring Buffer memory batch monitoring
To check duplex coillinstruction codes, etc. in
programs
6.9.3
nated addresses for the special-function mod- 6.9.5
Clock monitorino
To clear the entire memory of ACPUs and re-
turn to initial states
I
6.9.7 PC memory
All clear Program
Device memory
PC NO. setting
Mairvsub switching
Switching
To clear currently selected programs (mainpub) 6.9.8
To
clear all device memories except special D
and swcial M and R
6.9.9
PC
system OTHERS (0)
I
To switch applicable operating programs in all
ABPUE modes.
6.9.10
To switch applicable operating programs
(mairvsub) in all ABPUE modes
I
6.9.11
To forcibly switch ACPU execution states
(RUN/STOP)
To read and write in machine language for the
memory of ACPUs
6.9.1 2
6,9,,3
Remote RUN/STOP
Others
lwritina
Program mode selection
To set whether or not writing is executed when
programs are in the RUN state, and whether or 6.9.14
not only the MONITOR and TEST are utilized.
To set whether or not the continuity of each in-
struction i s displayed when the list monitoring 6.9.15
function is used.
To
set whether or not buzzer is ON/OFF when
a key is pressed.
6.9.16
PU
setting
Continuity display
Buzzer setting
3 - 5