Configuring A Tunnel - ZyXEL Communications ZyWall 110 User Manual

Hide thumbs Also See for ZyWall 110:

Table of Contents

Figure 261 6to4 Tunnel

10.8.1 Configuring a Tunnel

This screen lists the Zyxel Device's configured tunnel interfaces. To access this screen, click Network >

Interface > Tunnel.

Figure 262 Network > Interface > Tunnel

Each field is explained in the following table.

Table 117 Network > Interface > Tunnel

Chapter 10 Interfaces

Click this to create a new GRE tunnel interface.

Double-click an entry or select it and click Edit to open a screen where you can modify the

entry's settings.

To remove an entry, select it and click Remove. The Zyxel Device confirms you want to

remove it before doing so.

To turn on an entry, select it and click Activate.

To turn off an entry, select it and click Inactivate.

Select an entry and click References to open a screen that shows which settings use the

Section 10.5.4 on page 328

This field is a sequential value, and it is not associated with any interface.

ZyWALL USG Series User's Guide

for an example.

Show Quick Links

Table of Contents