Port Configuration - ZyXEL Communications ZyWall 110 User Manual

Chapter 10 Interfaces
The physical Ethernet ports are shown at the top and the Ethernet interfaces and zones are shown at the
bottom of the screen. Use the radio buttons to select for which interface (network) you want to use
each physical port. For example, select a port's LAN radio button to use the port as part of the LAN
interface. The port will use the Zyxel Device's LAN IP address and MAC address.
When you assign more than one physical port to a network, you create a port group. Port groups have
the following characteristics:
• There is a layer-2 Ethernet switch between physical ports in the port group. This provides wire-speed
throughput but no security.
• It can increase the bandwidth between the port group and other interfaces.
• The port group uses a single MAC address.
Click Apply to save your changes and apply them to the Zyxel Device.
Click Reset to change the port groups to their current configuration (last-saved values).

10.3 Port Configuration

Use this screen to configure port settings. Click Configuration > Network > Interface > Port Configuration
in the navigation panel to display the configuration screen.
Note: You can't configure the speed and duplex mode of the fiber ports on the USG2200 and
UGS2200-VPN.
Figure 240 Configuration > Network > Interface > Port Configuration
ZyWALL USG Series User's Guide
302