Bridge Summary - ZyXEL Communications ZyWall 110 User Manual

Hide thumbs Also See for ZyWall 110:

Table of Contents

In this example, virtual Ethernet interface lan1:1 is also removed from the routing table when lan1 is

added to br0. Virtual interfaces are automatically added to or remove from a bridge interface when

the underlying interface is added or removed.

10.10.1 Bridge Summary

This screen lists every bridge interface and virtual interface created on top of bridge interfaces. If you

enabled IPv6 in the Configuration > System > IPv6 screen, you can also configure bridge interfaces used

for your IPv6 network on this screen. To access this screen, click Configuration > Network > Interface >

Figure 268 Configuration > Network > Interface > Bridge

Each field is described in the following table.

Table 124 Configuration > Network > Interface > Bridge

Configuration / IPv6

Configuration

Create Virtual

Chapter 10 Interfaces

Use the Configuration section for IPv4 network settings. Use the IPv6 Configuration section

for IPv6 network settings if you connect your Zyxel Device to an IPv6 network. Both sections

have similar fields as described below.

Click this to create a new entry.

Double-click an entry or select it and click Edit to open a screen where you can modify the

entry's settings.

To remove an entry, select it and click Remove. The Zyxel Device confirms you want to

remove it before doing so.

To turn on an entry, select it and click Activate.

To turn off an entry, select it and click Inactivate.

To open the screen where you can create a virtual interface, select an interface and click

Create Virtual Interface.

Select an entry and click References to open a screen that shows which settings use the

Section 10.5.4 on page 328

This field is a sequential value, and it is not associated with any interface.

ZyWALL USG Series User's Guide

for an example.

Show Quick Links

Table of Contents