Auto Track Function; Using The Menu - Tascam SS-R1 Owner's Manual

Auto Track function

Auto Track recording is a function that automatically
assigns a new track number when the specified condition is
satisfied during recording. A new audio file is created each
time a new track number is assigned.
You'll use the menu to select Auto Track mode and make
detailed settings. However, the Auto Track mode setting
itself can be made using the

Using the menu

(For details on menu operations, refer to "Operations in the
menu screens" on page 16).
1 Press the key to access the main menu list
MENU
screen.
2 Select the REC menu.
3 Select the AUTO TRACK item.
4 Turn the
MULTI JOG
keys) to select the Auto Track
CURSOR § , ¶
mode from the following choices.
:
OFF
New track numbers will not be assigned automatically.
:
LEVEL
A new track number will be assigned when the signal
exceeds the auto track level (specified in the screen for
detailed settings described below) after having stayed
below it for two seconds or longer.
Level
A_TRACK
LEVEL
:
DD
When recording a digital source (CD, DAT, MD) via the
DIGITAL IN jack, a new track number will be assigned
when a track division is detected in the source.
However when recording an analog source or a digital
source other than those listed above, this will operate as
LEVEL mode, and a new track number will be assigned
according to the input level.
A.TRACK key of the remote.
dial (or use the remote's
At least
Track increment
2 sec
Time
6 − Recording
If the Auto Track function is on, A_TRACK will light in the
home screen.
Auto track settings can be made at any time, and you can
change the settings after you start recording.
NOTE
If you've recorded in WAV format, you'll be able to
use editing functions to divide or join tracks after
recording (see "Operations in the file menu screen"
on page 50).
:
T I ME
A new track number will be assigned at a fixed interval of
time (specified in the screen for detailed settings described
below).
5 If you selected a choice other than
front panel key (or the remote's
˚
key) to proceed to the screen for detailed settings.
6 Make detailed settings for the function.
• If is selected
LEVEL
Use the LEVEL item to specify the level at which Auto
Track will operate.
You can set this in a range of -72 dB – -24 dB (6 dB steps).
(The default setting is -54 dB).
Use the DELAY item to specify the time (in units of one
frame) from when a signal exceeding the auto track level is
detected until the new track number is assigned (one frame
is 1/75th of a minute).
You can set this in a range of -75 frame – +75 frame (the
default setting is 0). Negative values will cause a portion of
the signal prior to the detection point to be captured.
NOTE
If this range is converted into time, the adjustable
range is equivalent from -1.00 minutes to +1.00
minutes.
, press the
OFF
CURSOR ¥
1
TASCAM SS-R1