Tascam SS-R1 Owner's Manual page 66

Tascam solid state stereo audio recorder owner's manual
Hide thumbs Also See for SS-R1:
Table of Contents

Advertisement

14 − Specifications
Storage disk
Recording/playback formats
Number of channels
Analog inputs
Analog Outputs
Phones output
Digital input (COAXIAL)
Digital output (COAXIAL)
CONTROL I/O
REMOTE IN connector
Frequency response
Distortion
S/N ratio
Dynamic range
Crosstalk between channels

TASCAM SS-R1
CompactFlash card
MP3: Sampling frequencies: 44.1 kHz, 48 kHz
Bit depth: 16-bit
Data rate: 64, 128, 192, 256, 320 kbps
WAV: Sampling frequencies: 44.1 kHz, 48kHz
Bit depth: 16-bit
2 channels (stereo)
Balanced XLR-3-31 equivalent
Nominal input level: +4 dBu
Maximum input level: +20 dBu (*1)
Minimum input level: -6 dBu or greater
Input impedance: 22 k
Ø
Unbalanced RCA pin jack
Nominal input level: -10 dBV
Maximum input level: +6 dBV
Minimum input level: -20 dBV or greater
Input impedance: 22 k
Ø
Balanced XLR-3-32 equivalent
Nominal output level: +4 dBu
Maximum output level: +20 dBu (*1)
Output impedance: 100
Ø
Unbalanced RCA pin jack
Nominal output level: -10 dBV
Maximum output level +6 dBV
Output impedance: 200
Ø
Stereo phone jack (1/4")
45 mW + 45 mW or greater (THD+N: 0.1% or less, at 32
Connector: RCA pin jack (IEC- 60958-3 Consumer (S/PDIF))
Input sampling frequencies supported: 32 kHz – 48 kHz
Input impedance: 75
(unbalanced)
Ø
Variable gain amount: -∞ – +10 dBFS
Connector: RCA pin jack
Supported signal format: IEC- 60958-3 Consumer (S/PDIF)
Output impedance: 75
(unbalanced)
Ø
(RS-232C) connector
Communication protocol: Complies with RS-232C protocol specification 1.00
Connector: D-sub 9-pin connector
(PARALLEL) connector
Parallel control input/output
Connector: D-sub 25-pin connector
Maximum input voltage: +5.5 V
Minimum high level input voltage: +3.75 V
Maximum low level input voltage: +1.25 V
Output format: Open drain (voltage resistance 50 V, maximum current 50 mA)
Maximum low level output voltage: 0.5 V
For connecting dedicated RC-SS1 remote controller: Stereo mini jack
For connecting a PS/2 keyboard: Mini-DIN connector
20 Hz – 20 kHz, ±0.5 dB (for recording)
0.005% or less (AES-17 20 kHz) (for recording)
95 dB (AES-17 20 kHz, A-weighted, typical) (for recording)
95 dB (AES-17 20 kHz, A-weighted, typical) (for recording)
95 dB
load)
Ø

Advertisement

Table of Contents
loading

Table of Contents