Tascam SS-R1 Owner's Manual page 65

Tascam solid state stereo audio recorder owner's manual
Hide thumbs Also See for SS-R1:
Table of Contents

Advertisement

Power does not turn on
ª
Make sure that the power plug is firmly inserted.
ª
Media is not detected
Make sure that the CompactFlash card is firmly inserted.
ª
Can't play back
In the case of a WAV file, make sure that the file is of a
sampling frequency (44.1 kHz or 48 kHz) and bit depth
(16-bit) supported by the SS-R1. In the case of an MP3
file, make sure that the file is of a bit rate supported by
the SS-R1.
No sound
ª
Check the SS-R1's connections to your monitor sys-
tem. Also check the volume of your amp.
Can't record
ª
• Check the connections once again.
• Adjust the recording level.
A setting you changed is not remembered
ª
The SS-R1 backs-up the settings when you change
them. This backup may fail if you turn off the power at
an inappropriate time, so do not turn off the power
immediately after changing a setting.
Noise is heard
ª
Check whether a connection cable might have a bad
connection.
When editing a name, the display indicates
ª
Name Full
Due to limitations of the system, the number of charac-
ters in a file name and folder name is limited to 255
characters (single-byte). Since the full path within the
folder finder is limited to 255 characters, the maximum
name length for a file or folder that is inside a sub-fold-
er will be reduced by the number of characters used by
any folders above it and any separator characters.
13 − Troubleshooting
13 − Troubleshooting

TASCAM SS-R1

Advertisement

Table of Contents
loading

Table of Contents