IVT EA-52I Instruction Manual page 8

Instruction manual
TOOL SPECIFICATIONS
EN
No-load speed [RPM]
Displacement [cc]
Engine power [HP]
Rated power [KW]
Engine manufacturer
Engine model
Nr. strokes of the engine
Starting system
Type of engine cooling
Employed fuel
Fuel consumption [g/kWh]
Fuel tank capacity [L]
Max. diameter of mountable drill [mm]
Sound pressure level [dB(A)]
Sound power level [dB(A)]
Vibration level m/s
Weight - without bit [kg]
PART LIST
1. Power head (engine)
2. Auger bit (NOT INCLUDED)
3. Handle
4. Recoil starter
5. Fuel tank
6. Muffler
7. Throttle trigger
8. STOP/RUN switch
9. Air filter
10. Choke lever
11. Primer bulb
12. Screw plug for greasing
CONTENT OF THE BOX
Instruction manual (1 pc), Fuel mixing bottle (1 pc),
Spanner (1 pc), Hex key (1 pc), Spark plug wrench (1 pc).
INTENDED USE
This machine is designed to dig holes in the earth,
for fence or post installation, for large planting works,
environmental restoration and other construction
activities.
Installing an optional ice auger bit, this machine can be
used to bore holes also into ice, for ice fishing and for
construction works in icy conditions.
Model
2
recoil starter
air cooling
mixture - gasoline:oil = 25:1
114 (K=3)
97 (K=3)
6.5 (K=1.5)
SAFETY REGULATION FOR THE USE
General safety rules
The following listed safety instructions should serve you
for the right use of the tool and for the protection of your
own safety, therefore, please read this very carefully.
When passing this tool to a third person, these
instructions must be handed too.
Retain this user's manual and all other literature supplied
with your tool for any future reference.
Comply with all the safety information and the warnings
on the tool.
Be familiar with the controls and the proper use of the
tool before attempting to use it and above all, make sure
you know how to stop to use it in case of emergency.
Following these simple instructions will also maintain
your tool in good working order.
∙ The tool must be assembled correctly before use.
∙
Only use the tool for its designed purposes.
∙
On the tool, there may be also decals and further
indications about the safety equipment to use that
must be considered. The prevention of accidents is
dependent upon the awareness, common sense and
proper training of everyone involved in the operation,
transport, maintenance and storage of the tool.
∙ Never leave the tool unattended.
∙
Never allow children to use the tool. Children
should be supervised to ensure that they do not play
with the tool.
8
EA-52I
8000
52
2.4
1.8
Weili
1E44F
2
700
1.2
250
9.5