Unpacking And Mounting - TANDBERG 7000 MXP User Manual

TANDBERG 7000 MXP

2.1 Unpacking and Mounting

1 Unpacking
The TANDBERG 7000 MXP is delivered in one transport case with all components inside as
shown in figure 1:
Figure 1
2 Mounting of the base
Place the column with the bolts into the bolt holes on the foot as shown in figure 2. Secure the
column and the foot with nuts (nuts and wrench is found in the accessories box) by tipping the
base (column/foot) as shown in figure 3. Place the base in an upright position where the system
is supposed to stand.
Figure 2
3 Installing the monitor frame
Lift the monitor frame out of the transport case. Do not remove the protective plastic film from the
monitor front before the monitor frame is securely fastened to the base.
Place the monitor frame on top of the base. Make sure that the cables from the rear side of the
monitor frame do not get stuck between the base and the monitor frame.
12
Foot
Column
Monitor Frame with built-in LCD monitors
Monitor Rear Cover
W.A.V.E. II Camera
Accessories box which will contain the
following:
Two Table Microphones
Remote Control and Tracker with batteries
Cables
Documentation
Figure 3