Stereo Settings - TANDBERG 7000 MXP User Manual

5.5.4

Stereo Settings

Settings
Out 1 Stereo I/O
Mode* Mode
Analog Off
Analog Off
Analog On
Analog On
SPDIF Off
SPDIF Off
SPDIF On
SPDIF On
*Out 1 Mode: Auto/Analog/SPDIF is described in Outputs.
**L+R = Left + Right
When Stereo I/O Mode is Off and Stereo Speakers is Off, the output response will be a mono
loudspeaker signal on Audio out 1, AUX on Audio out 2 and VCR on Audio out 3 regardless on
the Out 1 Mode setting.
In analog mode the Stereo Speaker On will provide a stereo loudspeaker signal on Audio out 1
and 2.
If Stereo I/O Mode is On, audio input 5 and 6 and audio output 2 and 3 will behave as a stereo
input/output pair, VCR-left and right. The VCR Ducking and AGC setting for audio input 6 will in
this case apply to both audio input 5 and 6. The Audio out 2 (VCR-left stereo channel) will be a
mix of the microphones and the far end left channel. Audio out 3 (VCR-right stereo channel) will
be a mix of the microphones and the far end right channel. (Note that stereo speakers set to on in
analog mode will provide a different scheme, see table above for details).
If Stereo I/O Mode is Off, Audio out 2 will be a mix of audio input 6, microphones and the far end
(the received far end signal is either mono, or stereo that is summed left+right into mono in near
end codec). Audio out 3 will be a mix of audio input 5, microphones and the far end. (Note that
stereo speakers set to on in analog mode will provide a different scheme, see table above for
details).
Note that in SPDIF mode, you are able to receive stereo through Audio out 1 independent of the
Stereo I/O mode setting.
Stereo Audio out 1
Speakers
Off Loudspeaker
mono
On Loudspeaker
left
Off Loudspeaker
mono
On Loudspeaker
left
Off Loudspeaker
mono
On Loudspeaker
L+R**
Off Loudspeaker
mono
On Loudspeaker
L+R**
Administrator Settings
Output response
Audio out 2 Audio out
3
AUX VCR
Loudspeaker VCR
right
VCR-left VCR-right
Loudspeaker VCR
right
AUX VCR
AUX VCR
VCR-left VCR-right
VCR-left VCR-right
179