Stereo Settings - TANDBERG 3000 MXP User Manual

D1335704_T3000_MXP_User_Manual
4.5.4

Stereo Settings

Settings
Out 1 Stereo input
Mode* mode
Analog Off
Analog Off
Analog On
Analog On
SPDIF Off
SPDIF Off
SPDIF On
SPDIF On
*Out 1 mode: Auto/Analog/SPDIF is described in Outputs.
**L+R = Left + Right
When Stereo Speakers is Off, the output response will be a mono loudspeaker signal on Audio
out 1 and VCR on Audio out 2 regardless on the Out 1 Mode and Stereo Input mode settings.
In analog mode the Stereo Speaker On will provide a stereo loudspeaker signal on Audio out 1
and 2.
If Stereo input mode is Off, Audio out 2 will be a mix of audio input 3, microphones and the far
end (the received far end signal is either mono, or stereo that is summed left+right into mono in
near end codec). (Note that stereo speakers set to on in analog mode will provide a different
scheme, see table above for details)
If Stereo input mode is On, Audio out 2 will be a mix of the microphones and the far end. (Note
that stereo speakers set to on in analog mode will provide a different scheme, see table above for
details)
If the system is connected to a Digital NAM, stereo sound on the loudspeakers shall be
present if a stereo input signal is connected to the inputs VCR-Left and VCR-Right or a stereo
signal is received from the Far End.
If the system is not connected to a Digital NAM, stereo sound on the loudspeaker outputs
will be present in the following situations:
156
Stereo Audio out 1
Speakers
Off Loudspeaker
mono
On Loudspeaker
left
Off Loudspeaker
mono
On Loudspeaker
left
Off Loudspeaker
mono
On Loudspeaker
L+R**
Off Loudspeaker
mono
On Loudspeaker
L+R**
Output response
Audio out 2
VCR
Loudspeaker
right
VCR
Loudspeaker
right
VCR
VCR
VCR
VCR