Power Cable - TANDBERG 880 User Manual

3. ISDN cables
• CConnect the ISDN cables to the ISDN sockets (S/T-interface) provided by the service provider. Your main
number will be the number associated with the socket to which ISDN cable number 1 is connected.
NOTE
S
OME SYSTEMS AND SOFTWARE VERSIONS DO NOT SUPPORT THREE
North America: The system does not have a built-in network terminator. If your wall socket provides you with an ISDN
U-interface, you will need an NT1 between your system and your ISDN line, see Appendix 1.
NOTE
W
RITE DOWN THE NUMBERS ASSOCIATED WITH EACH OF THE
C S
NOTE
ONNECTING TO THE
. P
ON THE SYSTEM LEASE REFER TO

4. Power cable

• Connect the power cable from the system's power connector to an electrical distribution socket.
5a. LAN cable
• To use the system on LAN, connect a LAN cable from the 'Ethernet' connector on the system to your LAN.
5b. Wireless LAN - Insert PC Card
• Remove the "dummy" card by pressing the 'Eject' button next to the slot.
• Insert the Wireless LAN PC Card.
M
NOTE
AKE SURE YOU INSERT THE CARD IN THE RIGHT DIRECTION
'E '
THE JECT BUTTON POPS UP
See 'Wireless LAN Settings' for configuration.
TANDBERG Videoconferencing System
56 : W
WITCHED NETWORK HEN CONNECTING TO THE
A 2
PPENDIX FOR FURTHER INFORMATION
.
ISDN
LINES
ISDN . Y
LINES OU WILL NEED THEM LATER TO CONFIGURE THE SYSTEM
S 56
WITCHED NETWORK YOU MAY USE ONE OF THE
.
(
WITH THE PRODUCT LOGO POINTING UPWARDS
13
Installation
.
BRI
INTERFACES
). P
USH THE CARD INTO THE SLOT UNTIL