Wireless Lan Settings - TANDBERG 880 User Manual

Wireless LAN Settings

SSID (Service Set Identification)
Example "WLANNETWORK". Defines a local network id for this wireless region. It must be the same for all end
points and the access point. An endpoint will find the access point if the SSID is correct, however if the
encryption key is faulty it will not transmit any data.
Community (optional)
Community can be used when connecting to an access point where the SSID is the same. Example "Unit2".
WLAN Mode
AdHoc: Used when not communicating with an access point.
Managed: Used when communication is made through an access point.
Restart
Make sure the corresponding settings are programmed into the access point. Press "Restart" in order to activate
the settings.
Required cards
• Compaq WL110 11 Mbps Wireless LAN
• Lucent Orinoco 11 Mbit/s SILVER
• Lucent Orinoco 11 Mbit/s GOLD
• Cisco Aironet 350 series (AIR-PCM 350 series)
• Enterasys Networks RoamAbout 802.11 DS High Rate
• Melco Buffalo WLI-PCM-L11G
T PC C /PCMCIA-
NOTE
HE ARD CARD USED MUST COMPLY WITH THE RELEVANT REGULATIONS FOR SUCH CARDS IN THE COUNTRY WHERE IT IS USED
) P B SPN-270-12,
ADAPTER OWER OX
TANDBERG Videoconferencing System
WHICH COMPLIES WITH THE REQUIREMENTS FOR LIMITED POWER SOURCE ACCORDING TO
Recommended access point
• Compaq WL410 base station
IEC/EN 60950
79
Advanced use
.T
HE UNIT MUST BE SUPPLIED BY POWER SUPPLY
(AC-DC