Table of Contents
Advertisement
im Vertrieb von
Operation, cont'd
Example 11: Viewing and adjusting an output volume level
The following steps show an example in which the audio output volume is viewed
and adjusted. The steps show the front panel indications that result from your
action.
Audio output volume is displayed differently on different models. See the table on
page 3-42.
For this reason, figure 3-68 and figure 3-71 show the indications displayed on a
switcher with 12 output buttons without duplicating all of the actions shown in
figure 3-67 and figure 3-70, which show switchers with 32 output buttons.
Figure 3-69 and figure 3-72 show the indications displayed on a switcher with 16
output buttons.
1.
Figure 3-65 — Clear all selections
2.
Figure 3-66 — Select Audio mode
3.
Press and release
the Output 17 button.
The button lights
green.
Figure 3-67 — Select output 17
www.camboard.de
3-44
CrossPoint 450 Plus and MAV Plus Switchers • Operation
CAMBOARD Electronics
Press and release the Esc button (figure 3-65).
Press the Esc button to clear all selections.
C O N T R O L
VIEW
ESC
ENTER
PRESET
The button flashes once.
Press and hold the Audio button for approximately 2 seconds (figure 3-66).
2 seconds
AUDIO
Press and hold the Audio button until it blinks.
= Blinking button
Press and release the output 17 button (figure 3-67).
The input buttons display the selected output's audio volume level.
Each lit input button beyond input 1 indicates 3 percent of the total input volume is applied to the
output. The flashing button indicates an additional 1.5 percent.
In this example, the green input buttons indicate 41.5 percent of the applied audio input. The unlit
input buttons indicate an audio volume attenuation of 39 dB.
O
1
U
T
P
U
17
T
S
= Unlit button
= Blinking button
Tel. 07131 911201
Fax 07131 911203
AUDIO
–39 dB attenuation,
41.5% volume
1
2
3
1
12 13
17 18
19
2
7
28 29 30 31 32
= Lit button
ce-info@camboard.de
I
14 15 16
N
P
U
T
S
Advertisement
Table of Contents
