Example 9: Viewing And Adjusting An Output Volume Level - Extron electronics CrossPoint 300 84 User Manual

Operation, cont'd
See the table on page 3-31 to read the volume display.

Example 9: Viewing and adjusting an output volume level

The following steps show an example in which the audio output volume is viewed
and adjusted. The steps show the front panel indications that result from your
actions.
Audio output volume is displayed differently on different models. See the table on
page 3-31. For this reason, figure 3-52 and figure 3-54 show the indications
displayed on a switcher with 16 output buttons without duplicating all of the
actions shown in figure 3-51 and figure 3-53, which show all actions on switchers
with 12 output buttons.
1.
Figure 3-49 — Clear all selections
2.
Figure 3-50 — Select Audio mode
3-32 CrossPoint 300 Matrix Switchers • Operation
For example: When lit steadily, the Input 3 button indicates the following,
depending on the number of input buttons the switcher has:
Switchers with 12 input buttons — 47 dB of attenuation when compared
to the Input 3 LED blinking quickly (48 dB to 50 dB of attenuation). The
blinking Input 4 LED (45 dB to 46 dB of attenuation) is at least 2 dB less
than the fast blinking Input 3 LED (48 dB – 46 dB) and at most 5 dB less
(50 dB – 45 dB).
Switchers with 16 input buttons — 52 dB of attenuation when compared
to the Input 3 LED blinking (53 dB to 55 dB of attenuation). The blinking
Input 4 LED (49 dB to 51 dB of attenuation) is at least 2 dB less than the
fast blinking Input 3 LED (53 dB – 51 dB) and at most 6 dB less
(55 dB – 49 dB).
Press and release the Esc button (figure 3-49).
Press the Esc button to clear all selections.
CONTROL
ENTER PRESET VIEW ESC
Press and hold the Audio button for approximately 2 seconds (figure 3-50).
Press and hold
the Audio button.
I/O
2 seconds
RGBHV AUDIO
Volume is protected when front panel lock mode 2 is selected. You can view
the volume in lock mode 2 but not change it from the front panel.
If front panel lock mode 2 is selected and you try to perform steps 3 and 4, the
actions are ignored and the Enter, RGBHV/Video, and Audio buttons flash.
The LED
blinks once.
The LED blinks to indicate
Audio mode.
Release the button.
AUDIO