Changing The Front Braking System Fluid - Husqvarna TR 650 TERRA 2013 Workshop Manual

TR 650 TERRA 2013 - TR 650 STRADA 2013
2
1
3
3
BRAKES
Changing the front braking system fluid
- Remove the rubber cap (1) from the valve (2) on the brake calliper.
- Insert the end of a transparent hose in the valve (2) and the other end in a
container.
- Undo the screws (3) and remove the cover (4) of the fluid reservoir (6) with
the relative bellow (5).
- Pull the lever (7) of the brake and keep it pulled, loosen the valve (2) and
wait for the oil to come out, then tighten the valve (2) and release the lever
(7).
- Repeat this procedure a few times until all the fluid has drained.
H11880
- Fill the reservoir (6) with the new fluid.
- Pull the lever (7) of the brake and keep it pulled so that the system remains
under pressure, loosen the valve (2), tighten the valve (2) always with the
lever pulled, then release the lever (7).
4
- Top up the fluid level (6) and repeat a few times the procedure described in
the line above until the system is completely full and the clear fluid begins to
come out without bubbles from the transparent hose.
- Fill the reservoir (6) with the correct quantity of fluid.
After replacing the fluid, bleed the system on both callipers and on
H11856
the master cylinder as described in the relevant paragraph.
4
5
6
H11857
7
H11858
L.17
Workshop Manual Ed. 09-2012